|  | 
| 
			 
			#11  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			Hey there... I just found some nice size single lights, like you mentioned.  If I want to tie them into my spare switch on the dashboard, do I have to run from the battery to that switch and then back, or just from the switch back to the lights? I have never even checked to see if there are cuddy lights, or for that matter if there are any lights hooked up to a switch!!! I guess I'll have to. 
				__________________ 1987 Wellcraft v20 Steplift Tavares, Florida ================ | 
| 
			 
			#12  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   Quote: 
 Is there a fuse panel with a +12v and Neg bus under the dash? In some way.... you will need +12v from battery thru a fuse to the switch, then to all of the LED's +wires and a connection of all LED Neg wires to the Neg battery. Do not connect LEDs in series( in + out - into+ out - ...etc) Connect them in parallel. they all must have (from switch)+12v on their + wire and All must connect their - wire in some way to the Negative battery (aka Ground or Common) 
				__________________ 1984 V20 "Express" & 2003 Suzuki DF140 (SOLD!) 2000 GradyWhite 265 Express YouTube/SkunkBoat https://www.youtube.com/channel/UC4F...znGospVOD6EJuw Transom Rebuild https://www.youtube.com/watch?v=EEz94NbKCh0 https://www.youtube.com/watch?v=Oe_ZmPOUCNc | 
|  | 
| 
 | 
 |