|
|
#31
|
|||
|
|||
make sure the fuel connetor is tight on the motor or remove both mercury fuel connector ends and splice the hoses together with doubled ended brass nipple :) from ace hardware.
|
|
#32
06-11-2008, 12:22 AM
|
|||
|
|||
|
Tim should i tighten down the nut that holds the flywheel all they way down it can go? i hit it with the impact but didn't know if i should go all the way down. i'm having a problem now where the starter gear stays up on the flywheel gears and wont seat back down.
would my engine still spark if one of the safety switches is malfunctioning? i was thinking maybe my "run" switch on the controll box itself is messed up.
|
|
#33
06-11-2008, 06:52 AM
|
|||
|
|||
|
Just disconect the kill switch wires (black with yellow stripe). . . if you think that's your problem. I'll look up the torque spec on the flywheel, but I've never had a problem with mine when I hammer down the nut with an impact wrench.
|
 |
|
|
Linear Mode
