dash panel

[keepitgreen05]

hello i am from central NJ and i have a 87 steplift i am looking to redo the dash when the guages are does anyone know about how much it will cost for a simply 4 gauge set up and redo the plastic. and if so where can i have it done at

[Destroyer]

Originally Posted by keepitgreen05

hello i am from central NJ and i have a 87 steplift i am looking to redo the dash when the guages are does anyone know about how much it will cost for a simply 4 gauge set up and redo the plastic. and if so where can i have it done at

Pretty much all of us here are wrench turners... meaning that we tend to do our own repairs and mods if possible. You can find nice gage sets on eBay for reasonable prices. As far as someone to do it for you, that's usually a local issue.. You'll have to find someone in your area that can do the work. I'd suggest a carpenter rather than a marina. He can make the dash panel and the cutouts for the gages, then all you have do is wire them up.

[keepitgreen05]

i was thinking of buying a peice of starboard and placing it over the old one and doing it myself do you think that will work

[RWilson2526]

Absolutely....like Destroyer said thats the way most do it....There was a guy on here that sponsored for a while that made custom setups with the Wellcraft logo and all....somebody here had one made and it looked awesome. I'll see if I can find but you can try a search....depending on what kind of tools you have you could spend a ton of money if you need to go out and buy hole saws and mandrels and all. I personally like black plastic by the way for a dash instead of white.

[ssiredfish]

I used Starboard on mine and I think it came out fine. Would of loved to have it angled up a tad more though.....

Look at second pic......
http://www.wellcraftv20.com/communit...ad.php?t=16103

[phatdaddy]

this is one made from ipe, similar to teak. vic,fellow member, made for me.

[spareparts]

kinda hard to see, but I made this dash with black plexi, I cut out all th holes and made the screw holes before I peeled the paper off. Then i sanded the edges smooth, ran across the edges with a propane torch(it work real good) to give it that finished look. I painted teh back side with black paint to make it look better

[reelapeelin]

Here is a '74 redo I did w/1/2" Starboard back in 1999

And a '95 V21 of 1/4" Starboard from last year...




If you are handy at all w/tools, it's not that daunting a task, but if you are looking for a super sharp factory quality dash panel, there is a contact in our Links section for one that can do it for you...

[stuarbc]

Here is the dash i had laser cut.....it was a guy i found off of classic-mako.com

[RWilson2526]

Originally Posted by stuarbc

Here is the dash i had laser cut.....it was a guy i found off of classic-mako.com

Ahh....thats the one I was referring too.....That does look sweet....how much did it cost you if you dont mind me asking?