|
|
|
|
#1
|
|||
|
|||
Yamaha Oil Injection System
Recently, I have learned a bit about yamaha's oil injection system.
This link was very informative: http://www.bassandwalleyeboats.com/s...e_page_98.html 
|
|
#2
12-29-2003, 08:48 AM
|
||||
|
||||
|
Re: Yamaha Oil Injection System
Good link. Thanks ;)
__________________
Heavily medicated for your protection.
|
|
#3
12-29-2003, 03:27 PM
|
|||
|
|||
|
Re: Yamaha Oil Injection System
CB, what's with the winky ???
Don't tell me you alread posted that link on this site. :o
|
|
#5
12-29-2003, 05:25 PM
|
||||
|
||||
|
Re: Yamaha Oil Injection System
Thanks Seakindly for the fine read!!
I have been having a problem with overflowing! and have not figured it out I have been told by a few that it is the float switch in the main tank?? I have been told by a yamaha guy that it is the control unit?? But this articale says if the Cap on the main tank is not aligned it coud do this also?? I had it off at one point and don't ever remember lineing the Arrows up?? Could it be that simple?? Not for me!! But I am going to check. Thanks again!!
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#6
12-29-2003, 11:15 PM
|
||||
|
||||
|
Re: Yamaha Oil Injection System
No, I didn't post already. I just thought it was a good article. I usually reserve my winkies and kisses for MJ. :-*
__________________
Heavily medicated for your protection.
|
|
#7
12-30-2003, 12:00 AM
|
|||
|
|||
|
Re: Yamaha Oil Injection System
Seakindly,
Thanks for posting the link . . . this is a great article.
__________________
1971 222 Hiliner 1973 23 Seacraft Center Console 1973 23 Seacraft Sceptre 1971 25 Seacraft Seafari 1972 28 Cary
|
|
#8
12-30-2003, 03:51 PM
|
|||
|
|||
|
Re: Yamaha Oil Injection System
Macojoe, To test the shut off float switch on the engine oil tank, all you have to do is take the float assembly out of the tank and remove the strainer - then slide the float all the way up. if the upper float switch is working correctly - the remote tank pump will stop. If you slide it all the way down then alarms go off. at an in between position - a switch tells the remote pump to pump.
When you put the float assembly back in the tank, make sure the arrow and notches line up. The outlet nipple on the float switch/strainer assembly must sit in the very bottom of the tank outlet hole or else the float can bind. You can feel that it is in the groove by wiggleing it side to side. Good luck!
|
|
#9
12-30-2003, 03:55 PM
|
|||
|
|||
|
Re: Yamaha Oil Injection System
Also, if this works for you, don't forget to bleed the air out of the system, after you refill the tank, before you run the motor. :o
|
|
#10
12-30-2003, 04:07 PM
|
|||
|
|||
|
Re: Yamaha Oil Injection System
A good idea for anyone with a yammie:
Print out that article (no telling how long that link will last), and staple it to the inside back cover of your service manual.
|
 |
|
|
Hybrid Mode
