|
|
|
|
#1
|
|||
|
|||
Bare with me,more questions.
I know I'm asking a lot of questions but this site is my go to site
Today I was checking ignition wires for spark , I didn't have spark on the starboard side bottom wire so I pulled it out and it was broken at the coil end, would that cause it not to show park? Then I went up one plug, disconnected it and the motor bogged down and I had spark ( Good) Next I went to the top wire ( same side) and pulled the wire and had spark but there was no change in the motor , that's what I'm concerned about What do you think? Port side checked out good. It's a 1988 150 Mercury outboard 2 stroke and believe ie or not even with running on five plugs it sounds great I ordered new wires , two coils and I have the plugs so I'm going to change all of the above.
__________________
love to fish 
|
|
#2
10-09-2021, 04:30 PM
|
|||
|
|||
|
Why
__________________
love to fish
|
|
#4
10-09-2021, 09:26 PM
|
|||
|
|||
|
No I put why by mistake The first one is my question
__________________
love to fish
|
|
#6
10-10-2021, 11:13 PM
|
||||
|
||||
It's easy to do a continuity check on each wire. if you have a V.O.M. just set for Ohms and put one lead on each end of each wire and check for resistance. No change on the display = bad wire.
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless.
|
 |
|
|
Hybrid Mode
