|
|
|
|
#1
|
|||
|
|||
Steering cable lenth
I think im going to replace my steering cable since im going to take it off of the helm, does anyone know the lenth i should get? Its a wellcraft cuddy. 20 foot ofcourse. I think i put a 17 foot cable in before and it seamed to long but im not sure, thanks for anyhelp you can give me.
__________________
love to fish 
|
|
#2
12-25-2015, 07:15 PM
|
||||
|
||||
|
i9t should be written on the cable somewhere, usually in inches. Most often its located in the hardest to read place it could be, normally scraped half off
|
|
#3
12-25-2015, 08:20 PM
|
|||
|
|||
|
19 feet?
__________________
love to fish
|
|
#4
12-29-2015, 02:47 AM
|
||||
|
||||
|
Pull the old one and measure. Also it's a whole lot better to be too long than short, ask how I know. If you are even close to between sizes go up a foot.
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
|
#5
12-29-2015, 06:21 PM
|
||||
|
||||
|
Telflex says there a number on the motor end on plastic, the last 2 numbers on model number is how many feet, it the number is worn off the say measure the plastic only!! then add 18 inches and round off to the nearest foot. Or measure center of helm to gunnle then to transom then tothe center of motor then add 6 inches
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#6
01-01-2016, 04:22 PM
|
|||
|
|||
|
The reason I would like to know what size you guys put on your wellcraft is because when I replaced mine the last time it seamed kind of long so I'm thinking the shorter the better as long as it fits, less drag in the tube sleeve
__________________
love to fish
|
 |
|
|
Hybrid Mode
