|
|
|
|
#1
|
|||
|
|||
2 part questions thermostat and steering
1 is there any way to loosen up the steering I have a no feed back 4.2 turn to turn cable steering I took one nut off and sprayed penertrating fluid it worked the first time but when it got hard I did it again but I couldn't get it loose the secound time
2 I changed my thermostats can I clean and reuse the old ones ? Thanks for any advise I'm going striper fishing tomorrow I will give you a report Happy thanksgiving
__________________
love to fish 
|
|
#2
11-26-2015, 09:42 PM
|
||||
|
||||
|
replace the thermostats if you have them available, Pull the steering cable out of the steering tube and clean it out with a shotgun brush, grease the pivot tube on the engine as well
|
|
#3
11-27-2015, 10:27 PM
|
|||
|
|||
|
The problem is I can't get the steering rod out unless I remove the engine
__________________
love to fish
|
|
#4
11-27-2015, 10:30 PM
|
|||
|
|||
|
I forget to mention I was out in sandy hook today fishing for strippers and saw about 4 step lifts out there one was a v 21 The swells were very high and dangerous was anyone on this site out there too
__________________
love to fish
|
|
#5
11-28-2015, 10:00 AM
|
|||
|
|||
|
Hey spare you said grease the pivot tube? Does that have anything to do with the steering? I thought it only is for raising the engine when I disconnect the engine from the steering bracket it moves freely
__________________
love to fish
|
|
#6
11-28-2015, 10:22 AM
|
||||
|
||||
|
tilt tube is up and down, pivot tube is side to side to side, its the grease fitting on the side of the mid section
|
 |
|
|
Hybrid Mode
