|  | 
|  | 
| 
			 
			#1  
			
			
			
			
			
		 | |||
| 
 | |||
|  Anyone experienced removing bow railing ? V21 
			
			Plan to remove, " waterproof" and re set the bow railing over the winter. Wondering if it's a straight matter of just uncrewing or any surprises ? | 
| 
			 
			#2  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			Plan for the worst and hope for the best. It is probably thru bolted. The nuts probably will not come off the bolts. You will need a second set of hands, pb blaster, etc. I tried drilling out the heads on the screws on some railing on the 18 Fisherman. All I did was burn bits up. I say spray them with pb blaster and you might get lucky and they unscrew.
		 
				__________________ 1983 V-20 capsized. . . . in the garage. | 
| 
			 
			#3  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			They are thru-bolted, but on that newer, well-kept V21 they should back right out ;P  It's a long reach, so a 2nd set of hands will definitely help, but I extended my deep well ratchet with a piece of PVC so that I could wedge it against the inside of the bow and hold the bolt while I turned the screws from the topside.  Worked out fine and I think I only had to drill out two.
		 | 
| 
			 
			#4  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   Truer words have never been spoken.   
				__________________ 1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless. | 
| 
			 
			#5  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			I did mine this past spring .I didn't even try to unscrew them even though I probably have done .But with no help I simply drilled the heads off the screws .Job didn't take long at all.
		 | 
| 
			 
			#6  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			Like said...pre spray w/PB Blaster...I've personally removed two bow rails off V20 and had good luck w/grabbing the hex-nut underneath w/a pair of vice-grips...they'll turn around til they stop against the inside hull...also like said, yours is a bit newer boat and I know better kept than the two I've worked on...
		 
				__________________ '74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha | 
| 
			 
			#7  
			
			
			
			
			
		 | ||||
| 
 | ||||
|   
			
			tie a string to the vice grips.... makes retrieval much easier.
		 | 
|  | 
| 
 | 
 |