Gas tank hatch

[Ambush]

Should the hatch over the gas tank be caulked around the seam? I took it up to clean the connections for the gas guage wiring. Still does not read...

[Destroyer]

I wouldn't, but if you feel you have to then I'd suggest that you use a removable caulk and you should be fine. Dap Seal & Peel would be my choice. It goes on clear and you can peal it off if needed.

[macojoe]

i used 4200 on mine, it will come off if i need it too. but do nothing till you get the gauge working!! you don't :want to do it then find you have to take it off again

[Ambush]

Ok 10:4

[RWilson2526]

Originally Posted by Destroyer

I wouldn't, but if you feel you have to then I'd suggest that you use a removable caulk and you should be fine. Dap Seal & Peel would be my choice. It goes on clear and you can peal it off if needed.

Destroyer did you maybe think he meant the small pie plate over the fuel sender? I think its a must that you seal the hatch that covers the entire tank (assuming I am reading it right). Any water that gets into the tank coffin will not drain as it is sealed so it's must. By the way I used clear 100% silicone on mine based upon a recommendation here and it looks good against the gray floor.

[SkunkBoat]

Originally Posted by RWilson2526

... I think its a must that you seal the hatch that covers the entire tank (assuming I am reading it right). Any water that gets into the tank coffin will not drain as it is sealed so it's must. By the way I used clear 100% silicone on mine based upon a recommendation here and it looks good against the gray floor.

DITTO!!!! Definitely seal it....seal it with clear silicone. cheaper than 4200 and works great, pulls out when you need it to

[Ambush]

Originally Posted by SkunkBoat

DITTO!!!! Definitely seal it....seal it with clear silicone. cheaper than 4200 and works great, pulls out when you need it to

Yes I ment the hatch not the little round access port...

[jeffmo]

I sealed mine after painting w/ silicone caulking.It's pretty easy to remove and I'm glad it is because i have a corner that came loose and now I have to remover it and re-glue the wood backer.