|
|
|
|
#2
04-05-2011, 02:41 PM
|
||||
|
||||
Assuming the V-21 has the same drains as the V-20, this is the best thread discussing the various ways people have skinned that animal.....
Welcome to the site by the way.. http://www.wellcraftv20.com/communit...ht=deck+drains
__________________
1986 V-20 1986 Yamaha 150 HP 
|
|
#4
04-05-2011, 06:25 PM
|
||||
|
||||
|
Quote:
RW turned you on to a good source...a good example of what this forum's all about... If nothing there does work for you, I just put new drains in a '95 21 last year and found all I needed at West Marine, including SS thru-hulls...the thru-hulls were pricey, but the drains were priced OK...Hammer states in RW's link that you need to use 90* drains...I agree...you also need to use check vales, too...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#5
04-07-2011, 08:56 AM
|
||||
|
||||
|
Quote:
__________________
1986 V-20 1986 Yamaha 150 HP
|
|
#6
04-08-2011, 06:54 AM
|
||||
|
||||
|
Quote:
Well, Bruiser...had yer Wheaties this morning I see...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha
|
|
#7
04-14-2011, 11:18 AM
|
||||
|
||||
I just got my 93 V-21 home and need to do the deck drains as well. Were did you find the check valves they must be the inline type or did you find a set of through hulls with a ball float type set up in them. The ball assembly would be the better of the two and the only one I have been able to find are the sculpers that are a bit bigger in diameter and the outlet is 1 1/2". you just have to do some minor mods to make them work I would like to leave the boat alone and not cut it up any one out there find some the same size???
|
 |
|
|
Hybrid Mode
