|
|
|
|
#1
|
|||
|
|||
Mercury spitting out water where it should not be
Yesterday I noticed my 1996 Mercury 115hp 2 stroke was spitting out water from where the midsection meets the powerhead. I am wondering what it could be, a bad seal somewhere in there?
|
|
#2
07-07-2010, 07:27 PM
|
||||
|
||||
|
Others will be on here later than know yr motor better than I do but it may be like my small Johnson, the pisser tube (flexible) falls inside the motor housing and leaks from the midsection.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
#3
07-07-2010, 07:46 PM
|
||||
|
||||
|
inside of cowl, stb side? Thats the poppit valve letting you know it needs replacing
|
|
#4
07-08-2010, 06:49 AM
|
|||
|
|||
|
How difficult is this to DIY? I'm pretty comfortable wrenching but I have limited marine engine experience. If its going to be a big project to get at it I'd rather give it to someone else to do, its too hot to keep her down for too long.
|
 |
|
|
Hybrid Mode
