Deck Overhaul { Need Help}

Blu_Lunch · #1 06-21-2010, 06:39 PM

I had a couple of soft spots on the V-17 deck I was going to wait till next year to fix it. While sanding the bottom to paint I found where the boat was sitting on a bad roller had damaged the keel about 2 inches worth{ it worn thru several layers of glass and it was forming a drip of water on it overnight there was 2 drips. Seeing that I decided to redo the deck and at the same time add several layers of glass from the inside to the area and Marine-Tex and re contour the damaged area. I took out the 5 1/4 finish circular saw and left about 3 inch lip all around. It did not go through completely in spots. Should I recut the entire deck through or peel the top layer and remove the little squares that made the deck. What's the correct way to remove the floor? I hope skools can guide me through this...............

joe7670 · #2 06-21-2010, 08:20 PM

I cut all the way through and removed the glass and wood from the back side to reuse the top "finished" part of the floor.

Sawzall helped in my case for areas where the circular saw didn't make it. I was also very careful to not cut though to the point where the circular saw cut the stringers.
http://www.wellcraftv20.com/communit...t=floor&page=2

Blu_Lunch · #3 06-22-2010, 02:56 PM

The deck is out, I have a small stringer repair to do on the port side ahead of the rear bulkhead it was not glassed from the factory and there was some minor rot for about 1 foot worth that's it. Next the foam has some water about inch worth's the rest is dry. What's the best way to remove the foam?

joe7670 · #4 06-22-2010, 03:40 PM

Sawzall will work for the big stuff. Drywall manual saw should work too.

Pressure cleaner also works very well. Wear goggles as it will fly everywhere.

Blu_Lunch · #5 06-22-2010, 09:01 PM

I 'll be cracking out the pressure washer tomorrow..............

Blu_Lunch · #6 06-23-2010, 03:49 PM

Got in there today it's tropical here, removed half the foam and it came out easy, found more damage the entire center stringer is gone and need to replace 3 feet on the port side stringer and the same where the tray goes for running cables and the rear bulk head bottom 2 inches is marginal. Need advise on wood for the stringers, the center 110x9.5x1 can I use 2 pieces of marine plywood glued or resin and encapsulated in 9oz cloth and resin. And the bulk head I hate to tear it out it only has a very small amount of damage can I just add to it. Something interesting the center stringer at the bow end is attached to a bulkhead only and the bulkhead is not attached to anything and never was, no sign of it ever being glassed. I plan on encapsulating all the new wood, the glass the new stringer with 24 oz mat a single layer. That's what Wellcraft did with the bare wood.