No trim under power

BigAl331 · #1 07-02-2009, 10:16 PM

I've tried to find something about my trim problem and nothing. So here goes:

Tilt/trim motor will tilt and trim when there is no pressure on the foot by the motor under power. I can trim up as long as the motor is off or at an idol in gear.

Once it is up it will slowly go back down. When I lift the motor the only way I can get it to stay up I have to put the tilt lock in place.

I looked at the fill port and it is full, with the motor up and on the lock. If I take the screw out it will leak hyd fluid. The manual tilt screw had bubbly pink fluid but I think I bleed it out all the way.

Does anybody have an idea of what it might be? I really don't want to replace the entire unit just yet.

Skools Out · #2 07-02-2009, 10:28 PM

you have a bad seal on the main cylinder

BigAl331 · #3 07-02-2009, 10:51 PM

Quote:

Originally Posted by Skools Out

you have a bad seal on the main cylinder

How hard is it to replace? I got a manual but it doesn't show the tear down.

Skools Out · #4 07-02-2009, 11:06 PM

better off to let a shop replace the seals as most use and require special tools

Enforcer · #5 07-02-2009, 11:35 PM

yep I tried to fix once and it was junk, had to get shop to do it the second time.

What motor is this?? If it is a Merc BS must have one he sell you cheap

spareparts · #6 07-03-2009, 07:16 AM

make sure the tilt release screw is tight