![]() |
|
#1
|
|||
|
|||
|
Hey Guys I just bought a used prop offa ebay, The dude said it was from an omc v4......It doen't fit mine. I have a 13 spline 1" shaft, This prop has 13 splines but the bushing is for a 15/16" shaft. Is there a way to swap the bushings?
__________________
|
|
#2
|
||||
|
||||
|
I would think the prop was for a SUZUKI or HONDA then if it doesn't fit. Pretty much all of the V-4 OMC's used the same propeller shaft configuration unless it was really old and used a shear pin. SUZUKI had some smaller diameter prop shafts though.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD ![]() AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 |
|
#3
|
||||
|
||||
|
Having one rehubbed (if possible) can cost near what a new one would be.
Keep looking, good experiance. I did the same thing, got the right tooth and spline but wrong exhaust diameter, heck $35 for an unused prop, couldn't go wrong. Come to find out it fit another motor I had.
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny Last edited by tsubaki; 05-23-2008 at 04:44 AM. |
|
#4
|
||||
|
||||
|
But will give a little comparison.
http://www.portcityprops.com/repairs.html http://www.properpitch.com/opr.asp
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny Last edited by tsubaki; 05-23-2008 at 04:52 AM. |
|
#5
|
||||
|
||||
|
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny |
|
#6
|
|||
|
|||
|
you know something
you think your saving money and it cost you more[me too] i am not going to by anything on ebay alot of people have gotten defective stuff and its not that cheap now you have to go out and try to get her repaired or another one time is fish and boating time
__________________
love to fish |
![]() |
|
|