Power steering, fix it or remove it?

rb437 · #1 04-21-2007, 07:34 PM

Getting the boat ready for the season and I noticed the power steering pump resivoir was very low on fluid. I added fluid, and started the boat and started looking for leaks. Found the hydraulic cylinder leaking. Appears to have rusted through. It looks like a pretty simple replacement if I wanted to spend the money (but I don't). What do you guys think? Do I really need it? I guess I could take the belt off the pump and run it without and see what it feels like.

willy · #2 04-21-2007, 10:37 PM

Rick not sure of your set up, but if it is an older power steering set up with a pto and pump on the engine with a belt you are going to find it a bear to steer without it. Different ratio (gearing) on them.

spareparts · #3 04-22-2007, 01:12 AM

assuming its a Mercruiser, replaceing that cylinder isn't too bad( its not that easy either), but parts are getting scarce and expensive for teh old saginaw type units, teh later style( identified by not having any external steel lines) will swap in, and I've seen those for $100-$250 from some of the salvage shops

rb437 · #4 04-22-2007, 09:49 PM

Yes it's Mercruiser Alpha 1. Any one have a good source for the updated version at a good price.

THEFERMANATOR · #5 04-23-2007, 12:32 AM

I've seen them go on E-bay for under $50. You'll also have to go with new style lines(or find an adapter) if you go with the updated ram.

rb437 · #6 04-23-2007, 11:11 AM

I bet I'll have to do the lines regardless. As you can see from the picture they're kinda rusty.

THEFERMANATOR · #7 04-23-2007, 12:48 PM

Here's 2 on E-bay right now.

http://cgi.ebay.com/ebaymotors/Mercr...QQcmdZViewItem
http://cgi.ebay.com/ebaymotors/Mercr...QQcmdZViewItem

And here's a new old style ram.
http://cgi.ebay.com/ebaymotors/Mercr...70969682QQrdZ1

rb437 · #8 04-23-2007, 09:04 PM

Thanks Therm, This one is same as what I have. A little more money than the others but should install with no mods.

http://cgi.ebay.com/ebaymotors/Mercr...70969682QQrdZ1

So I just called them on the phone and ordered one. Should be here Thursday. E-bay listing allowed you to make an offer so I asked for a better price on the phone. Bought it for $125.00 plus $14.00 UPS MI to MD. They said they had a few of them because they were leftover new stock from a SeaRay dealer they took over. If all goes well there will be pictures of the installation to post by this weekend.

Hey Spareparts or anyone else got any tips, tricks or warnings on the install on this? I'd be happy to learn from your experiance rather than learn the hard way.

THEFERMANATOR · #9 04-23-2007, 10:12 PM

I just changed the one in my SEARAY project earlier today(sorry no pics today), pretty straight forward job. Be careful taking the lines off if there rusty though.

rb437 · #10 04-25-2007, 03:27 PM

Step 1 of steering cylinder replacement done. soaked all the rusty fittings with PB blaster while waiting for new part to arrive. Expecting it to arrive tomorrow.