getting there - Wellcraft V20 Community

06-09-2016, 08:59 PM

Troutkiller2006 Troutkiller2006 is offline

Senior Member

Join Date: Jan 2016

Location: long beach mississippi

Posts: 140

getting there

notched the cap so the motor would mount flush and mounted the motor. got trim tabs installed. the hole for the controls was too big so i made a plate out of some scrap 3/16 aluminum plate

Attached Images

	IMG_1584.jpg (46.2 KB, 28 views)
	IMG_1583.jpg (76.0 KB, 30 views)
	IMG_1569.jpg (42.2 KB, 24 views)
	IMG_1570.jpg (38.5 KB, 24 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -5. The time now is 05:47 PM.