First V20 and its a project.

[GillV20]

So here is the deal, I found this V20 1988 20'6" for sale. I paid $400 for it. It is complete except trailer and the motor is obviously shot. I have a 1995 3.0 225 Mercury I will be putting on it. It is coming off of my 22' Hurricane deck boat. But the windshield is complete with no issues. The bimini is complete...well the hardware is there. the floor is completely solid, the very top of the transom has a little movement to it when you push hard on the lower unit of the outboard. I am thinking I will either add an aluminum angle bracket to it or two 2x6's fiber glassed in on the inside. The hull is in good condition, but I am going to completely sand it down and paint it then I think re gel coat it? I am not so up on the best way to make the hull look showroom. I love the hull design and it has all I am looking for. I just want to get it in almost show condition before I put it in the water. But there really isn't too much to do. Except some sanding and painting. Idea's or insight?