Have not been on the thread lately

[Big Lar]

BEEN WORKING ON THE BOAT AND PARTYING.

GOT THE STORAGE SEATS IN PLACE, NEED TO FINISH, TRIM AND PAINT.

DECK PAINTED

PRELIM PLUMBING FOR THE LIVE WELL ONE.

MADE A "CABINET" TO GO OVER THE LIVE WELL THAT WILL HAVE A SMALL SINK AND SALT WATER WASH DOWN.

TOOK THE INSIDE CAPTAINS SIDE PANEL OFF AS i AM MAKING NEW LOWER TRIM PIECES AND IT HELPED A LOT TO INSTALL THE TRIM TABS. THE HYDRAULIC PUMP IS BEHIND THE PANEL SO SHOULD BE DRY. ALSO NEEDED TO RUN WIRES FOR THE TRIM TABS, SO BEFORE I RE ATTACH WILL RUN WIRES FOR THE LIVE WELL PUMP AND THE WINDLASS. AND VERIFY THAT THE BILGE PUMP WIRING IS OK.

HOPEFULLY WILL TAKE THE BOAT TO THE TRAILER GUY TO MOVE THE AXLES.

IF ALL GOES WELL PLANNING ON MY MAIDEN FISHING JOURNEY LATER THIS WEEK. SOME OF THE WORK WILL NOT BE DONE, BUT THE REMAINING WORK WILL NOT AFFECT FISHING.