|
|
#1
|
||||
|
||||
Quality Jack Plates
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20 
|
|
#2
10-11-2014, 04:55 AM
|
||||
|
||||
|
__________________
 '75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny
|
|
#3
10-16-2014, 11:13 AM
|
||||
|
||||
|
http://www.bobsmachine.com/
http://www.thmarine.com/products/Out...ic-jack-plates  I finally replaced a solenoid on the 18 year old Bob's Hydraulic Jack Plate (original was still pulling closed but would not deliver any current through the contactor). It is a direct match to the old style Mercury trim pump solenoids of which I have extras in a box on a shelf. Happy Happy. If someone only made a switch that could hold up to the Florida sun, salt spray, etc. I think I replaced the switch 3 times in 18 years.
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS Last edited by RidgeRunner; 10-17-2014 at 02:00 PM.
|
|
#4
05-18-2016, 11:13 PM
|
||||
|
||||
|
I put a TH Marine Atlas jackplate on my 19 ft skiff and am very happy with it.
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
