General consensus on speed with Evinrude etec 200 HO

[bgreene]

I'm dreaming of an Evinrude etec 200 HO for my 96' V21.

To fuel the dream, tell me about the performance:
1. lift to plane
2. rpm's to cruise at 35- 40
3. top speed

Thanks

[THEFERMANATOR]

I wouldn't do the 200HO as that is a big block design and just a waste of torque in my opinion for a V-20. Genie ave has one on his though I believe. Personally I would think the 175 ETEC would be ideal followed by the 150 OPTIMAX.

[cterrebonne]

I had a 200/225 Ficht on my V20 with a bracket and though I would hit 50mph wot. It felt like too much weight on the back of the hull.

[reelapeelin]

I think you should get performance/fuel numbers from Lumberslinger on his smallblock 200 Etec before you go out and buy a BIGBLOCK HO for your 21...roughly 100 lbs difference in the two motors...IMO the smallblock 200 Etec is the way to go on these hulls...

[bgreene]

I don't plan to get an etec, just asking about the performance, thanks

[cterrebonne]

Originally Posted by bgreene

I don't plan to get an etec, just asking about the performance, thanks

if i remember correctly, I had a 19" brp rebel on the engine and the hole shot with no tabs was quick. it jumped on top. wot like i said set up properly with and 200ho 52-54 I would think. I didn't have any fuel burn #'s