freakin out 2 - 72 sep cap, a bust?

[Megan Flaherty]

I will add the new picures the old ones are on the first freakin out.

Cap is seperated and propped up in the back. 1972 only the rail is attached to the cap. Floor is attached to the side with glass about 1/2 way up.
Need a picture of the hull/stringers on this boat cause I am going to start cuttin. I was attempting to make a peep hole the bottom of the rear splash pan. Dumb idea was bottom of pan, 3/4 damp plywood, then shell?
Frustratedddddd.
Megan

picture 001 - high part of transom
picture 002 - transom with cap/pan seperated
picture 003 - side of hull under cap. basically one piece
1/8 plywood and 1/8 glass seem to married to seperate.
picture 004 - more of side
picture 005 - more of side.

[reelapeelin]

Well you got some decisions to make...do the work to get this hull back in shape or find another, more suitable hull to go with...plenty of work to be done there...if you are handy and ready for a project, dig in...

[Megan Flaherty]

Way Crazy this 1972 hull is 3 pieces.
Seems like it would be nice for this forum to build a list of hulls etc.
Any way the biggest problems I can tell are the thru hull in the splashwell had a large but not very visable crack running around it. I thought it was leaking into the hull. But removed some of the bottom of the splashwell and it was leaking into the let call it liner. Now I want to inspect the stringer and fix the bottom 1/2 of the interior transom leaving the top half connected to the linner not to change the origninal structure. I also need to check the pipe that runs from the splash up to the 3 well in the boat. I guess this self draining stuff. found a nylon blue and white rope and fished it up thru the center rear well drain.
Bizaare seems like a bumper rope but it might have to do with the pipe. Wish I had an infra red camera. Any more thoughts.
Have seen some good deals but always gone buy. Also not much budget I might just have to keep scratching and clawing at this one.
Salt Water Madness....