|
|
#1
|
|||
|
|||
Hydraulic Helm Test
Is there a way to test the helm without having the cylinder? Noticed that my boat came with hydraulic helm, but I don't have the cylinder.
Trying to figure out if I need a full setup or just the rear cylinder and new lines? Hopefully the helm is good to avoid more $$ spending. 
|
|
#2
09-02-2009, 01:47 PM
|
||||
|
||||
|
What kind of helm is it? To really test it you need a ram or to make some sort of manifold to check the pressure that each side can make. If it is the old HYNAUTIC system I would reccomend ditching it as parts are not really available for them anymore and are getting pretty worn out as they haven't been produced for some time.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
