|
|
#1
|
||||
|
||||
1991 225 Evinrude
Hey guys, just a quick question...
The 91 Hydra I'll be looking at on Friday is leaking fluid out of the trim/tilt area... I don't know much more than that. The guy was quoted $600 to fix... Here's my question: Would either one of these units fix the problem and is it easy to change out? I would be pulling the motor to do the work. http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=003 http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=001
__________________
 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ 
|
|
#2
04-16-2008, 11:04 PM
|
||||
|
||||
|
well yes and no, they will fit a V4 no mods but on a V6 looper will require you to change the tilt pin bushings and replace the lower bolt to a rod as the V6 ones use. i's say jusy buy a V6 looper one.
__________________
 1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#3
04-16-2008, 11:21 PM
|
||||
|
||||
|
It looks like up until 90 that either of those would work, but 91 went to the pin style like SKOOLZ talks about according to the BRP catalog. You would need a FASTRAK style if it is a 91 trim and tilt.
Or another option would be to take this unit http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=001 and remove the tilt tube and trim ram pin. And then use the the clamp brackets from it and swap it over to the other engine set-up. The FASTRAK style trim and tilt fetch's a pretty penny even on EBAY used.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
Last edited by THEFERMANATOR; 04-16-2008 at 11:44 PM.
|
|
#4
04-17-2008, 01:57 AM
|
|||
|
|||
|
Hey Ferm - How much are the fasttrak units going for . . . I have a trim and tilt for a 1995 200 that I need to sell off (actually a complete mid-section). . . would that work?
|
|
#5
04-17-2008, 07:56 AM
|
||||
|
||||
|
Guys, I thought the Fastrak units were for 96 and newer motors
 If I do need a Fastrak, then would this one work?: http://cgi.ebay.com/ebaymotors/OMC-J...QQcmdZViewItem
__________________
1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ Last edited by Bygracealone; 04-17-2008 at 08:08 AM.
|
|
#6
04-17-2008, 08:05 AM
|
||||
|
||||
|
Quote:
Skools, hopefully I will eventually learn what to look for between loopers and crossflows, but for now I'll lean on you and Ferm and BS and CB, etc... This is the engine. So, is it a looper or crossflow?:  
__________________
1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/
|
|
#7
04-17-2008, 05:09 PM
|
||||
|
||||
|
That is a looper, never seen a 225 cross-flow(cross-flow came in 200 and 235). The FASTRAK style actually came out in 91 on the V6 loopers according to the BRP catalog. The easy way to tell is that a pre-91 will bolt in and a fastrak will be held in with a big pin. I seen that used ones were bringing $400-500 on Ebay. There was also a V4 and a V6 style FASTRAK unit. Don't know what the internal differences are, but my CLYMERS shows 2 different FASTRAK'S.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664
|
|
#8
04-17-2008, 05:20 PM
|
||||
|
||||
|
Thanks for that Ferm,
Seeing that I will need a Fastrak, would this one work?: http://cgi.ebay.com/ebaymotors/OMC-J...QQcmdZViewItem
__________________
1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/
|
|
#9
04-17-2008, 08:43 PM
|
||||
|
||||
|
i don't think it willbe a fast track my 92 225 doesn't have fast trac andno the old V4 and V6 ones don't just swap. different in several places i learned from trying to do the swap. those BRP books aren't always right don't trust that.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#10
04-17-2008, 09:38 PM
|
||||
|
||||
|
Okay, so then the first ones I posted would work, right? These ones:
http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=003 http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=001
__________________
1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/
|
 |
|
|
Linear Mode
