Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs
Register FAQ Community Calendar Today's Posts Search

Reply
Thread Tools Display Modes
  #1  
Unread 03-18-2008, 11:22 AM
fishingwithblue's Avatar
fishingwithblue fishingwithblue is offline
Senior Member
 
Join Date: Mar 2008
Location: Richmond Hill, GA
Posts: 371
Default fuel tank

Can anyone point me in the right direction in replacing a fuel tank in an 84 steplift cuddy. I just bought the boat and at the place where I bought it the guys were replacing the fuel bulb before the seatrial. I wondered if they spilled gas in the bilge during the process but not sure. When I looked at the tank through the inspection holes it looked original(metal) and a somewhat suspect to be leaking. Advice?

Dumb question: should I not run it until I find out if there is a leak?
Reply With Quote
  #2  
Unread 03-18-2008, 11:45 AM
Mulv80 Mulv80 is offline
God
 
Join Date: Aug 2005
Location: Philadelphia, Pennsylvania
Posts: 1,398
Default

I would definitely wait to run the boat till you know if the tank is leaking or not. Your life could depend on it. As far as the tank itself do a search, there have been alot of threads regarding gas tank issues. If you are interested in a 40 gallon tank, Ebay seller Greatlakesskipper has a couple for $129 + shipping.
Reply With Quote
  #3  
Unread 03-18-2008, 12:07 PM
Blue_Runner's Avatar
Blue_Runner Blue_Runner is offline
Administrator
 
Join Date: Aug 2004
Location: Lexington, North Carolina
Posts: 9,234
Default

FWB how much fuel do you think the tank has in it? Full? Half? 1/4?
__________________

1994 Wellcraft V21
Reply With Quote
  #4  
Unread 03-18-2008, 12:39 PM
tsubaki's Avatar
tsubaki tsubaki is offline
God
 
Join Date: Mar 2007
Location: Savannah
Posts: 4,971
Send a message via ICQ to tsubaki
Default Welcome to the site.

Scoot it (the boat) out with the garden hose, remove the plug, wick the bilge out or dry with a wrag then start looking for accumilations of fuel in the bilge.
Most likely, you can repair it but this will involve removing the tank.
If it is leaking replacing it will be inevitable but a patch might buy you some time.
__________________

'75 Cuddy with '00 Johnson Ocean Pro 150 horse

Benny



Last edited by tsubaki; 03-18-2008 at 12:52 PM.
Reply With Quote
  #5  
Unread 03-18-2008, 04:21 PM
macojoe's Avatar
macojoe macojoe is offline
Administrator
 
Join Date: Mar 2003
Location: Carver, Ma.
Posts: 15,859
Send a message via AIM to macojoe Send a message via Yahoo to macojoe
Default

Like said above clean and dry the bilge and then look for signs of a leak?? If you find nothing then you could get the tank pressure tested to find out for sure.
If you have to take it out, its not going to be fun!! Lots of work and a new 60 gal tank will be $500+ so if you don't have a need for 60 gal you might want to ck out the 40 gal thats a nice price!!!!!
__________________
1986 V20

Old Fishermen never die, we just SMELL that way!!
Reply With Quote
  #6  
Unread 03-18-2008, 05:25 PM
tsubaki's Avatar
tsubaki tsubaki is offline
God
 
Join Date: Mar 2007
Location: Savannah
Posts: 4,971
Send a message via ICQ to tsubaki
Default

CAREFUL about the pressure test. Usually 3-5 psi is all the pressure added to check for a good tank.
__________________

'75 Cuddy with '00 Johnson Ocean Pro 150 horse

Benny


Reply With Quote
  #7  
Unread 03-18-2008, 05:26 PM
fishingwithblue's Avatar
fishingwithblue fishingwithblue is offline
Senior Member
 
Join Date: Mar 2008
Location: Richmond Hill, GA
Posts: 371
Default thanks

Quote:
Originally Posted by Mulv80 View Post
I would definitely wait to run the boat till you know if the tank is leaking or not. Your life could depend on it. As far as the tank itself do a search, there have been alot of threads regarding gas tank issues. If you are interested in a 40 gallon tank, Ebay seller Greatlakesskipper has a couple for $129 + shipping.
switching to a smaller tank may be a good idea as I fish alot inshore/nearshore
Reply With Quote
  #8  
Unread 03-18-2008, 05:32 PM
tsubaki's Avatar
tsubaki tsubaki is offline
God
 
Join Date: Mar 2007
Location: Savannah
Posts: 4,971
Send a message via ICQ to tsubaki
Default

Figure 10.5 gallons per hour to 2.5 miles per gallon at best running capabality.
If you're going to the CAT reef, 40 gallons would be a good size to leave room for error.
__________________

'75 Cuddy with '00 Johnson Ocean Pro 150 horse

Benny


Reply With Quote
  #9  
Unread 03-18-2008, 05:37 PM
fishingwithblue's Avatar
fishingwithblue fishingwithblue is offline
Senior Member
 
Join Date: Mar 2008
Location: Richmond Hill, GA
Posts: 371
Default

I filled the tank when I got it home before launching. So, it's sitting pretty tied up to the dock with a quart of live shrimp and mud minnows in a bait bucket hanging from the back cleat....fish or possible death by explosion? Guess i'll try to dry it out and observe. Does anybody have a ballpark figure on what the average fiberglass boat repair man charges to do the job of tank removal and replacement?
Reply With Quote
  #10  
Unread 03-18-2008, 06:05 PM
tsubaki's Avatar
tsubaki tsubaki is offline
God
 
Join Date: Mar 2007
Location: Savannah
Posts: 4,971
Send a message via ICQ to tsubaki
Default

Where you at? Kilkenny, Ft. McCallister or somewhere else?
This would be a good project to do yourself. There are couple of threads on replacing the floor tank if needed. No it ain't easy but it will work or not, nothing inbetween.
First pull the boat out and determine what's going on.
__________________

'75 Cuddy with '00 Johnson Ocean Pro 150 horse

Benny


Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:57 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.