|
|
#1
|
|||
|
|||
hydraulic steering helm installation
hello
I am installing a telestar hyd steering for my 86 v20 with a Evinrude 225. I notice the helm pump requires a smaller hole (3 in) and has a four bolt pattern. (PHOTOS INCLUDED) I was wondering if anyone has ever installed one and still had the 20 deg angle the black cover provides. thanks for any advice jet 
|
|
#2
10-26-2018, 10:28 PM
|
||||
|
||||
|
Put one on last year, the helm is not angled like the old cable helm was, just straight, was a little different getting used to it, but not bad. Still have two holes from the old bezel showing outside the new helm on each side, figured I'd cut a piece of wood to trim it out and cover them, kinda like a bezel. You'll love the butter smooth steering.
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
|
#3
10-27-2018, 11:31 AM
|
||||
|
||||
|
do you have the destroyer wheel like this or do you have the one thats more like a car wheel?
This worked great straight out.
__________________
1984 V20 "Express" & 2003 Suzuki DF140 (SOLD!) 2000 GradyWhite 265 Express YouTube/SkunkBoat https://www.youtube.com/channel/UC4F...znGospVOD6EJuw Transom Rebuild https://www.youtube.com/watch?v=EEz94NbKCh0 https://www.youtube.com/watch?v=Oe_ZmPOUCNc
|
|
#4
10-27-2018, 07:24 PM
|
|||
|
|||
|
i have the destroyer wheel
|
|
#5
11-06-2018, 04:34 PM
|
|||
|
|||
|
Well , thanks to boat outfitters, they made me a starboard round plate with 3 in center hole ($40.00) now my helm is installed.
Thanks all
|
 |
|
|
Linear Mode
