Engine wont start

[db971]

I recharged the battery today and fitted back into my boat. Switched on the ignition and the boat turned over but didnt start. I switched the ignition off then back on again, but there is nothing. I was wondering if it could be a fuse for the starter motor (everything else seems to work)? Any thoughts and pointers as to where to look for the fuse ( I have a Wellcraft 192 sport). Many thanks

[Hedge]

it could be the battery is not fully charged or maybe bad. Did you try another battery?

[aussie]

start with the basics check if you have spark and fuel and what engine you have on it would help

[Genie Aye]

Originally Posted by db971

I recharged the battery today and fitted back into my boat. Switched on the ignition and the boat turned over but didnt start. I switched the ignition off then back on again, but there is nothing. I was wondering if it could be a fuse for the starter motor (everything else seems to work)?Many thanks

Well it would not be a fuse for the starter if it is cranking over.

As Aussie said--check for spark, then check for burnable fuel. After you check thoselet us know what you come up with and we will see what else we can help ya with.

[db971]

Thanks for your replies. The engine did initially turn over, however when I switched off then back on there was nothing, not even a click from the starter motor. All the electrics seem to operate, I can raise and lower the inboard volvo penta engine in and out of the water, work the water pump etc. I would be surprised if the battery didnt have the power to turn over the engine, this is why I thought more about the starter motor (even with little power in the battery I would have thought I would here the solenoid coil on the starter clicking)? Thanks

[macojoe]

sounds like starter to me, also ck the ground wire!

[spareparts]

jiggle teh shifter and try to restart. If that doesn't work, check the main wire harness plug on the engine, make sure its tight and secure

[chumbucket]

Starter solenoid or neutral safety switch. Try jumping the solenoid terminals with a screwdriver. If nothing happens, check out the neutral safety switch on your control box.