New to this site and New to the V-20

[Bpitz15]

Hey guys,

I picked up this 1983 Step-lift cuddy with a 2003 Suzuki 115 4-stroke (http://wellcraftv20.com/community/sh...ad.php?t=19197) a little over a month ago and have been working on as much as possible after my work hours.

So far I have....:
1. Purchased a Veada lounge seat in all white with legs and storage (http://veada.com/boat-lounge-seats/b...s-ld20014.html). I have not installed it yet, but that will come in a week or two. I went this route to make the GF and friends happy when I'm not taking the boat out fishing.

2. I have used a rubber wheel to strip off all adhesive stickers, pin striping, old emblems, etc... This process has left what looks to be in tact wax or gel coat where the rest of the boat has oxidized. I am still looking into a way to repair or remove this lair before I polish and wax the hull. I may just cover them up with new pin-striping and new vinyl striping.

3. I have purchased MaryKates on&off, a fiberglass repair kit, rod holders, flag holders (for diving and USA!) teak cleaner with sikkens cetol, Protec boat detail kit, wellcraft emblems, and other odds and ends

4. I have changed all oils, filters, spark plugs on the Zuke' with all recommended brands and weights. This took the uncertainties out of purchasing a used motor and gave me peace of mind.

5. I most recently removed the abandoned 60 gallon fuel tank and cleaned out the hull of all debris. The previous owner tried the power washer method. I, fortunately had access to a mini-excavator and went to town with that. We managed to loosen the tank with the mini, but couldn't get the tank out since I left so much foam in tact. I ended up using a cutting wheel, cut a 1' section out of the middle of the tank and took it out that way. I did discover 3 different holes in the aluminum and discovered that all fiberglass was in tact underneath! The whole process of removing the tank and getting the foam removed took only 4 hours.

I have been searching the forum quite a bit and I think I have the 44.75" x 31" , 60 gallon tank, however the opening in the boat is 47.5"x32". I should have measured the tank prior to chopping it up, but I was in the zone. Can anyone give me a part number for a moeller gas tank that has been dropped into the factory location? I would like to purchase this as soon as possible, but havent developed a definitive answer as to which part number i could use. Any help would be appreciated here.



I am very excited to get this thing in the water (hopefully around July 4th) and I will absolutely keep this thread updated.


Brandon (MA,CT area)