|
|
#1
|
|||
|
|||
new floor
One of the boats I'm looking at will probably need a new floor, how much of a job is it with a V20? I've redone the floor on a runabout before and it wasn't too hard, just cut the old floor out, cleaned up foam and new foam (stringers were fine!) and glassed in new marine ply. It took me two weeks or so during the summer, but I'm pretty sure now that I know what I'm doing I feel like I could button it up in a few days, just didn't know how the Wellcrafts were built. Anyone here done somethin like this?
Thanks in advance!
__________________
'79 V20 Cuddy, '84 Johnson 140 '88 250 Coastal, twin '88 Johnson 140 '96 F-250 7.3L Powerstroke TD '94 Toyota Pickup 4x4 22re 
|
|
#2
04-15-2010, 10:16 AM
|
|||
|
|||
|
Plenty of posts on this around here.
Here is my thread from redoing mine last year: http://www.wellcraftv20.com/communit...ighlight=floor Here is one from skools: http://www.wellcraftv20.com/communit...ighlight=floor A few days may be a little tight. In my case once I did this I ended up doing fuel tank and lines... while I was at it.
|
 |
|
|
Linear Mode
