big shrimpin, need a part

[phatdaddy]

do you have the bottom yoke or collar for the steering arm shaft? i'm finally getting around to swapping out the bad one and would like to replace the bottom yoke as well,,
merc 150
thanks,

[bigshrimpin]

Phatdaddy - let me look and I'll PM you. I won't have bolts, mounts or nuts . . . but I am almost 100% sure I have a decent bottom yoke.

[phatdaddy]

BS also need a power trim & tilt unit for a 89, 90, 150 merc
let me know what cha got

thanks a lot.

[bigshrimpin]

PhatD - I have a yoke (unfortunately I don't have a good set of bottom motor mounts and bolts), but the yoke is decent. Also I have 4 trim and tilt units on ebay right now. 89 and 90 used the 3 wire setup. The unit that I have with the replacement motor is the best one of the lot. The other ones are the bottom of the barrel (mechanically fine and perfectly functional, but ugly). If you want one . . . I'll cover the shipping and throw in the yoke.

[phatdaddy]

i just callled your cell before i saw this. we also might need a stator for the same motor, do you have one for that same model & year?

edit: just found your store on ebay, looks good . i;ve got a donor motor and i'm gonna check it for the stator, i'll be in touch
thanks

[bigshrimpin]

Hey PhatDaddy - I am fresh out of 9/16amp stators. It's a pretty high demand item. I will be getting in a pair of 150/175 mercs after I get back from vacation. I should have one after the 22nd if you want to wait until then.

[phatdaddy]

thanks, the stator on my donor was ok, so we slapped it on with a couple of your switch boxes and fired that puppy up, also got the trim working, so gonna hold off on that now. i still need tha yoke, but it can wait

have fun on SPRING BREAK!!!!