|
|
|
|
#1
|
||||
|
||||
Greasing New trailer
Ok I have the new Loadrite trailer with its superlube set up.
In order to grease it you need to remove the rubber cap off the dust cover were there is a fitting and pump grease in till you see it coming out. Then clean up around opening and replace rubber cap. This sucks IMO!!! I just bought New Stainless Berring Buddys and i want to install them, But there is a grease fitting at the end of the axle were the adjusting nut is. Should I remove it?? or just leave it there and install over it?? This is the way I have always done it and the perferred way IMO Thanks guys
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#2
06-16-2004, 09:10 PM
|
||||
|
||||
|
Re: Greasing New trailer
I have just had how they are to work explained to me. It seems that the grease will go into the bearing and push the old grease out. Just wipe with a paper towel and replace rubber cap.
So now I have a set of 4 brand new stainless bearing buddys with bras here for nothing that i mail ordered
__________________
1986 V20 Old Fishermen never die, we just SMELL that way!!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
