|
|
|
|
#1
|
|||
|
|||
Stator question
I had a problem this fall, I was out and my engine started acting up, hard to start and felt like it was only running on 3 cylinders, I think it could be the switch box or the stator, when I started it on land it ran good,no problems. I know that the stator can go in and out, if I check the stator with a multimeter and it was running good at the time will it show on the test that it is no Good? Or does it have to be running bad when I test it to show that it is bad. Any info would be great
Thank you P.s. I am going to change the switch boxes this weekend.
__________________
love to fish 
|
|
#2
12-08-2020, 08:39 PM
|
||||
|
||||
|
what motor?
|
|
#3
12-10-2020, 01:59 PM
|
|||
|
|||
|
Hi spare, it's a 1988 150 Mercury outboard blackmax. Do you need the serial number? I'm taking my baby home this weekend and am going to replace the switch boxes and am going to test the stator .
__________________
love to fish
|
|
#4
12-10-2020, 02:01 PM
|
|||
|
|||
|
The last time I was out I came back on I think 3 cylinders so when I stated it on land it sounded like I t was running good, I know the stator and switch boxes can do that .
__________________
love to fish
|
|
#5
12-10-2020, 07:42 PM
|
||||
|
||||
|
if its missing on two cylinders, its the trigger. if it misses on three its the switch box. If it misses above 2000 rpm its the stator. BTW, if you replace the switch box, replace both of them
|
|
#6
12-11-2020, 08:21 PM
|
|||
|
|||
|
Thanks for the info spare, I did buy 2 switch boxes and will install them shortly, I hope that's what the problem is . Hey spareparts if you move to nj let me know lol but I dought you will move to nj, 25 dollars to use a boat ramp, friggin robbery
__________________
love to fish
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
