Re: Transom Modification
If it were mine and I was dead set on installing a merc I/O , Id follow skools advice. Cut as much plywood out from the inside to the outer skin. Leave the outer skin in tact. A 4an a half grinder works well with a 60 grit flapper sanding wheel. Grind all wood and glass out of the area to be refitted. Cut a template out of cardboard to fit that spot. Trace pattern onto marine ply,cut ply, sand to fit. Glass all back in, with resin and glass.
__________________
77 V20 cuddy with 170 I/O Mercruiser
72 16ft. Carolina w/a 25hp Evinrude
|