Re: Will It Work
As long as your anchor SHAFT will fit between the front roller and the horizontal pin above the roller, that looks like it'll work great...looks well made...you'll still have to feed chain, rope over back roller as it plays out, but that's no big deal...will you use a chain tensioner or bungee to keep anchor in stored position?...bungee (good ones and keep an eye on those) is fine IMO ;) 8) ...
Took picture of choc Krispy Kremes and hot coffee for ya this mornin', only to find new drive disallowed... :P ...
...and I don't consider those lights a mistake...may notta been zackly what ya had in mind, but they'll look/work good where ya pictured 'em last nite
;) 8) ...
__________________
'74 V-20/ BF 150
'95 V-21/ BF 150
'84 V-20/ 200 2.4 Merc
'87 V-20/'18 F150 Yamaha
|