Re: Holes in transom
You can tell we've all been through this movie before(patching holes). good answers all around. I wouold add a couple of suggestions. If you use skools tape trick, i use the clear shipping tape. that way you can see what is going on. i also inject the epoxy with a turkey injector. poke a small hole at the top of each side and fill the void. when it oozes out the hole, stop and all you have to grind is a small bit. also if you can mark your transom where the new holes are going, then drill out larger than needed. fill the holes with the tape method. then drill the holes the size you want and do a normal install. This will create an epoxy "bearing". and water intgrusion should not be a problem in the future.
|