[THEFERMANATOR]

It could be a fuel pump, but I doubt it since he said he gets fuel when he push's the key in for the primer(primer injects raw fuel using fuel pressure from the fuel pump). In your early posts you asked about jets, you got the 14's and 48's for it right? You put them in the right spots(14 in the top and 48 in the bottom)? Are you sure that you got the body gaskets seated in correctly when you put it back together(the rubber O-ring like gasket seals the idle and mid-range circuits to the base plate)? Are your plastic carb bodys warped?

First I would make sure the air bleed jets are in the right spots, this can be done by just removing the airbox. If they are in the right places, remove the plastic body's and tear them completely apart. Take a piece of VERY small wire and feed it into the jet pickups and make sure they are open. Also be VERY careful about what you spray on the carb body's, they are plastic and can be melted with most cleaners.

I may be able to break away one day and come help you take a look at it. I need to run down there and get my tanks VIZZED over at FANTASEA anyways. Shoot me a PM if your interested.