[macojoe]

Ok I have the new Loadrite trailer with its superlube set up.
In order to grease it you need to remove the rubber cap off the dust cover were there is a fitting and pump grease in till you see it coming out. Then clean up around opening and replace rubber cap.

This sucks IMO!!!

I just bought New Stainless Berring Buddys and i want to install them, But there is a grease fitting at the end of the axle were the adjusting nut is.
Should I remove it?? or just leave it there and install over it??

This is the way I have always done it and the perferred way IMO

Thanks guys