I got the new pump in today. wasn't too cold outside.
This is the old pump on a shelf I made to set it above the bilge pump, but below the deck level
shelf out with pump. *I made it so it sets on & over the stringers, so no drilling to stringers
Handyman, I put 3" pvc tubes between the gunnells and the outer hull below the rod boxes. *Capped both ends and put a tru hull in the cap. I tied both together at the pump, which is the lowest point of the set up. *I fill on the port side through the stand pipe under the boxes. *Capacity is about 5.5 gallons. *not very much but dosen't take up any room and is always in balance.
starboard side
port side with fill
