[reelapeelin]

Your boat's placard says I/O, yet it's sittin' there w/a Sea-Drive hangin' off the stern...sounds like as that hull went down the factory assembly-line as an I/O, it was diverted to the Sea-Drive assembly by mistake ... apparently it hasn't caused any probs, but if ya decide to ''go bracket'' especially ''full'', then you'll probably wanna add some more reinforcement ... provided all else is right w/ that hull, it'll sure be a worthwile conversion
;) 8) ...


Willy mentioned dunkin' ... a good way to avoid that is to get an outboard w/ a long shaft ... this will put the power-head higher above the water and less likely to ''dunk'' ;) ...