ok here's what all i'm sending back
Here's your original trim cover with long stainless screws for prethreaded holes in bracket
New made steering bracket
New Stainless Stering arm you needed with all nuts and washers plus tention spring
New Factory Steering bracket in case new one doesn't fit and new bigger steering trim cover
PS i'd use this trim cover it will cover better.
New Stainless Thru bolt parts 4 Stainless 5/16 Carriage bolts, 4 stainless washers, and 4 stainless nylon locking nuts.
Notice i polished the bolt heads so they look better on the top of your dash.
Just remember the new bracket mounts under the dash and then thru bolt from top with these new stainless bolts and trim cover will bolt threw the old steering hole. I hope this works and is that all you needed? Going out tomorrow via Priorty Mail.