[Mulv80]

Good first day Mike 8) As far as the transom in three pieces I think this is how they compensated for the curve. I'm not sure of the best way to match the curve of the transom. My plan was to epoxy (3) 1/2 inch sheets of plywood individually to the transom skin and pull it tight with screws and wood washers, then do the next 2 layers the same way till I got my 1 1/2. I figure thats the best way to get the curve. Then again I never did a boat transom before and my project V went to the crusher so take my advice lightly ::)