[macojoe]

I have 175 Yamaha with a 15 1/4x works nice for me!

I have been looking at trim tabs for a long time!! I have checked them out over and over, If I go with them I think I will be going with the Lenco electric.
I like the clean and simple install, over the Bennet.
But the Bennet is a little better system, as far as power.

I no a couple of people with the lencos and you have to raise or lower them one at a time, cause if you try to load them up at the same time you can burn out the motor.
But once you know that and rasie up un side at a time you never seem to have a problem.

I just hate to have one more oil set up on the boat!! I always always have a leak with oil stuff!! Oil and I just don't get along!!