Thread: Wellcraft V20 replacement of steering cable
View Single Post
  #4  
Unread 07-13-2021, 07:52 PM
Captnpopeye Captnpopeye is offline
Junior Member
  
Join Date: Jul 2021
Posts: 5
Default Success
I put a round stick in the trim tube moved it to the side of the well and marked it...drilled a 13/8" hole next to the existing whole.. installed the cable into the tilt tube NO PROBLEM..I picked up a new 3" rubber boot will install right next to the existing boot..will look fine and didn't have to touch the motor..TY for the replies..
Reply With Quote