Thanks for the welcome!
My motor is a 2004 yamaha z150 HPDI. It has super low hours, 283 hours.
I am not sure if that picture will come through, but we will see.
What is a stepside? I understand the hulls are the same betw
een the different deck layouts. Did WC only make 20.6 foot hulls back then?
I kind of hit a road block with rigging my motor and had to pull it back off to finish the rigging tube on the transom. I just did not have enough room to work with the motor on. the transom motor cutout is very small.
My problem is the hole that was there for a rigging tube is much bigger then the flange I have for my rigging tube.
I tried to upload some pictures, but they did not display.
Any tips? I am looking forward to getting on the water.
Oh I may have figured something out...difficult though...