Less than favorable weather this weekend so all I got done outside was some sanding to prep for priming and applying a coat of TotalFair to scratches and pock marks on the transom and keel.
But I was able to tackle one lingering project in the basement after I wrapped up glassing all the surfaces of the new tank platform. I went to work recoring the fuel compartment cover. A new piece of 1/2" MDO laid in with peanut butter. Then I filled the gap between the edge of the plywood and the lip of the cover with a blend of thickened epoxy, milled fiber and 1/4" chopped strand before wetting out a layer of 17oz biax over the back side. I am hoping that this mixture will allow me to countersink the screws which secure the compartment directly into the newly reinforced edge. 
The piece of ply covered with mylar tape sticking out the side is just a form to let me build up the edge where a hole had been cut in the edge of the cover for the original install of the cables to the console. Once the back side is set up I'll patch that glass on the topside and create a new hole with a proper dam around it for the console cables that ISN'T in the compartment cover.
Up next may very well be removing the hull from the trailer again and applying paint. Weather just has to cooperate. Stay tuned!
__________________
1987 V20 Center Console - Resto in progress
|