[Myfathersson]

DAMN it feels GOOD to start seeing the constructive side of this project and not just the destructive! Started on the ply sections for the transom today:







Once those were out of the way I prepped my stringer stock - I'm sawtooth joining like Slightly Twisted showed in his thread.







Peanut butter joints on the stringers are setting up overnight. Tomorrow it's back to grinding to get the rest of the stringer and bulkhead locations cleaned up. My second batch of grinding discs arrived this afternoon. After the grinding is done and I've washed the whole works down I'll set the first layer of the transom - hopefully tomorrow afternoon but Sunday morning most likely.