[Pipe_Dream]

Originally Posted by Slightly_Twisted

I’ve left the transom to fully cure, and have been working on the stringers.
Trying to get it right the first time I spent a few days measuring and re-measuring. I think I got everything where I want/need it so I cut the stringers.
They Came out good just need to fine tune them. The joint I decided I suck a scarf joints so I used what I call a saw tooth joint (not the right name). I decided to make the interlocking teeth 8in then glue them with peanut butter. The process wasn’t the bad just I was over measuring everything so I didn’t waste and plywood.

Hoping to have time this weekend to mock fit the stringers, bulkheads, and outside wedge pieces. Once I get things close I have to wait until the 16th to glass them in. I only have 1 or 2 gallons of resin left I know that’s enough for at least one side, but I really want to wait until I get another 5 gallons.

I’m planning on getting each stringer 100% glassed in one sitting to get a chemical bond throughout the whole stringer to boat connection.

Nice work!