Quote:
Originally Posted by Dschaffer
1). Repair the coolant leak. (Cam shaft sleeves)
2). Locate and repair the leak that is allowing water to mix in the trim reservoir.
3). Rebuild or replace the trim pump.
4). Add deck lighting.
5). Find and install new rod boxes.
6). Buy a 4 stroke 15hp kicker.
7). Buy and install a troll master speed controller for the new kicker.
8). Hope and pray the outdrive is in good shape.
9). Buy and install a Fish Hawk.
10). Buy and install Lenco trim tabs.
11). Install new big Jon rod holders.
12). Upgrade downriggers.
After the Cam shaft seals and trim pump, it pretty much became a wish list in no particular order. Hey, is there anybody on here in that lives/fishes in Northern Michigan?
|
Hello Dschaffer,
Just saw your post. I purchased a 1978 V20 Cuddy in 2017 and keep it in East Tawas. As expected, my project list is long. My maiden voyage was in Aug of last year. I ran about 40 miles on Lake Huron as was really impressed on how this 20 ft boat handled.
It has a 1980 200hp Merc which ran well at cruising speed, but idled terrible. I purchased a 10hp Tohatsu kicker which seems to be a good fit. I was able to mount in directly on the transom. My biggest concern is that the boat is stern heavy, so I moved my batteries forward. With the kicker was splash well drains were below the water level - pretty surprising. Hopefully this helps.
My list of projects for the spring: New fuel water seperator and in-line filter (there wasn't one); work on the Merc carbs; intstall new Cannon down riggers, tite-lok rod holders (I have a planner board set-up for walleye); new Blue Seas switch board, new deck mounted search light.
Last year I ripped the cuddy carpeting out, put new seats in her, installed a Raymarine Wi-fish set-up, etc...
This year, I hope to start walleye fishing in Saginaw Bay and salmon fish in Northern Lake Huron. May take a trip to Manistique (?).
This is such a great site...good people and a wealth of knowledge.