[Stevebbc]

Just bought this boat and it is in fairly good shape except soft spots in floor. i have a set of used trim tabs I bought and if I mount them in the optimum location, the hydraulic fittings and lines for the actuators will go thru the transom and be exposed in the splash well to salt water. If I mount them far enough outboard for fittings to go thru the transom and into the covered cap compartment, I will have to cut access panels to assemble and tighten actuator hydraulic fittings and lines. Wondering if anybody has run into this and what was their solution. it has a single 150 Merc but the transom appears to be cut to accept twins.