Great!
I'm gonna piggyback this thread...Ox66 225hp
Just took my lower units off for impeller change.
Found that "kits" didn't include enough parts.
There is a small metal sleeve and plastic spacer that really needed to be replaced due to years of wiggling off and on with pliers. Ordered them and 1 new Plastic Housing that was past its prime. The other one had been replaced recently.
Took a peek at the upper seals and the garter springs on both motors were broken and providing no tension. Not leaking and no water in oil but I'm gonna replace. They are doubled so I ordered 4. The diagram also shows an o-ring under the holder so I ordered 2.
Anybody hear that cash register dinging...???
Motor Guys. Is replacing them as straight forward as it looks?
Also there are so slightly leaking seals on 2 of the trim rams due to some slight pitting. smoothed it as best I could with 600 grit. Bought seals but didn't have "the tool". Tried half assed ways to remove.... ordered the tool.....ding!
|