I would spend the extra and get Anchor duplex marine wire 14/2. That keeps the red and black together ... easier and cleaner to run.
Depending on gauge of wire from LEDs (usually 18 or 22)...
if possible twist the LED to one end and insert in blue butt splice and crimp to other end. Continue down the line.
If LED leads are heavy, the twisted wires might not fit in a blue. They do make yellow/blue combos.
You could also twist all three together and just crimp them in a yellow splice.
Key is to seal out salt water.
I would n't use the T-Tap connectors that they use on trailers. TRAILER LIGHTS SUCK.
|